Camshaft and crankshaft errors. Ford error codes
AvtoAd
12/05/2022AvtoAd
12/05/2022Errors P0012 and others - according to the position of the camshaft. You need to check the compatibility of the labels.
Knock or camshaft sensor 1 is not working properly. You need to check the device.
Fault codes of the second detonation controller.
Errors P0335 and others indicate a malfunction of the crankshaft position sensor. The device may not start during shelf life. In fact, this problem is usually due to clogging of the contacts on the pad that is connected to the sensor. Therefore, before looking for the cause and troubleshooting methods, you need to check the connector itself.
Codes P0340 and P0341 report a malfunction of the camshaft. With the advent of the combination 0340 you need to check the operation of the shaft position controller, as well as clean its connector.
The camshaft is characterized by increased advance of its position. It is necessary to be convinced of synchronized work of pulleys.
Crankshaft and camshaft position mismatch. Error P0017 usually appears after replacing the timing belt if the user has marked the shafts incorrectly.
Codes Р003А and Р000В are translated into Russian as a fault of the intake camshaft clutch.
Code P0016 indicates a mismatch in the signals of the crankshaft and camshaft position controllers. You need to check the devices and the correctness of their connection.
Camshaft position sensor failure. You need to check the device, as well as its electrical circuits.
Piston and crankshaft timing error. It is necessary to make sure that the marks on the pulleys match.
Incorrect data on the crankshaft speed of the power unit. It is necessary to check the controller, and also to be convinced of correctness of adjustment of labels on the gas-distributing mechanism.