How to remove and install the all-wheel drive control unit J492 V generation

How to remove the all-wheel drive control unit J492 V generation

1. Disconnect connectors B and C from the four-wheel drive control unit A.

2. We unscrew the screws of the control unit of the four-wheel drive of the Haldex clutch and remove the control unit of the four-wheel drive A.

The installation of the control unit of the all-wheel drive J492 V generation is carried out in the reverse order.

Tightening torque:

The bolt of the four-wheel drive control unit to the Haldex clutch is 9.5 ± 0.5 Nm.