Audi C5 A6 how to set up a gasoline engine. Coding and diagnostics using the KKL Adapter and VAG COM, VCDS, VAS, VCP, ODIS, etc. Collection of codings VAG Group
Diesel engine settings:
Channel 01 - adjust the idle speed.
Channel 02 - adjusting the composition of the mixture, with increasing load. enrichment of the mixture under load.
Channel 03 - adjustment of the composition of the mixture, provided the load is reduced. Enrich the mixture by gently pressing on the sneaker or during deceleration.
Channel 04 - enrichment in the phase "after the start.
Channel 05 - enrichment in the "warm-up" phase.
Channel 06 - lambda control. Sets the speed of the controller response to change the signal from the lambda, large values.
faster, smaller values - the reaction is slower.
Channel 07 - additional speed limiter compensation. Set a limit by adding 1km / h.
Channel 08 - is responsible for enrichment in the "start" phase.
Channel 09 - compensation of the angle of advance of inflammation. Adjusts the angle with a step of 0.75 degrees throughout the speed range.
Channel 10-base fuel factor (works in all modes).
Channel 11 exhaust gas recirculation (EGR / AGR).
Channel 12-boost pressure settings, only for turbo machines, larger values increase boost pressure, lower values reduce boost pressure.
Channel 13 is not used.
Channel 14 - additional compensation of the moment on h.h. Regulates engine load at idle.
- APT / APU-01283, or 12830, or 07825, or 37825, 45678
- ADR (up to 97 years of issue) - 06589
- ADR (vin EBU: 8D0 907558) = 03256
- ADR (approximately after 98 years) = 02145
- ABC (only for blocks 400907 4730 / P) = 02102
- ACK ALF AGA-01283
- APU, APT, ADP, AWT: 01283, 12830, 07825, 37825
- ABC: 02102
- AFB - 26281
- ASN - 12380