Audi A6 C5 how to adapt a 4/5-speed automatic transmission with KKL Adapter and VAG COM, VCDS, VAS, VCP, ODIS, etc. Collection of codings VAG Group

AvtoAd

23/05/2022
Audi A6 C5 how to adapt a 4/5-speed automatic transmission with KKL Adapter and VAG COM, VCDS, VAS, VCP, ODIS, etc. Collection of codings VAG Group

Coding of a 4-stage automatic transmission


0007x: DSP mode (Dynamic Shift Points) :

 

  • 0 - DSP is enabled.
  • 1 = DSP disabled 000x ?: Operating mode.
  • 0 - factory (Adaptive behavior).
  • 1 - Economic (switching at lower speeds).
  • 2 - Sports (switching at higher speeds).


General settings:

 

  • 00000 - Factory mode.
  • 00011 - Economic regime.
  • 00012 - Sports mode.

 

 

Coding of 5-speed automatic transmission


Cable-operated gas pedal:

 

  • 00000 - Standard (DSP included).
  • 00010 = Standard (DSP disabled).


Electronic gas pedal:

 

  • 07xxxx: the presence of the tiptronic function - manual transmission.
  • 0 = No tiptronic buttons.
  • 1 - Tiptronic buttons present 0x? Xx: Switching strategy.
  • 0 - Old strategy (Shifts to first gear after a full stop).
  • 1 - new strategy (Automatically switches up and down to reach the speed limit, switches down when kicking down.
  • Oxx? X: Dynamic Shift Program (DSP - adaptive mode).
  • 0 = DSP enabled.
  • 1 = DSP disabled 0xxx ?: Region / Drive.
  • 1 - All-wheel drive (most countries).
  • 2 = All-wheel drive (North American region).
  • 3 - Front wheel drive (Most countries.
  • 4 - Front-wheel drive (North American region).
  • 6-speed automatic (Oi / Multitronic).

 

How to adapt the automatic transmission


To adapt, you need to turn on the ignition and start the engine. The temperature in the automatic transmission should be in the range from 60 to 90 degrees. Celsius during the procedure should be smooth, without abrupt opening of the gas and braking. To adapt, follow the instructions:

 


1. Select the Address of the control unit 02 Transmission control module.

 


2. Select function 10 Adaptations.

 

 

3. Select Channel 000 , read, save 000 .

 


4. Select function 08 Measuring blocks.

 

 

5. Select Channel 10 in one line and Channel 11 in another.

 


6. Select function 10 Adaptations in both windows.

Important: to adapt, you need to drive 20 meters (first forward) and stand on the brakes. Similarly, move about 20 meters back, stand on the brakes. You may need to manipulate up to 5 times until the adaptation is complete.

 

7. Exit the controller.

 

 

 

Read about Vasya Diagnost's VCDS coding here.