Adaptation is performed if we have not used the key before.
To adapt the keys to the immobilizer and CP, follow these steps.
Adapt the key to the immobilizer as follows:
1. Insert a new key into the ignition and turn on the ignition.
2. Open the instrument panel unit.
3. Log in with a login. Login is a four-digit number with a zero as the 5th character (at the beginning). It can be removed using Vag Tacho, K-CAN adapters. Commander. Or take it from the dealer (German dealers give a 7-digit code, the date of generation of this key and the workshop code-WSC. All this is entered in a special menu field "Login / Login". After entering the login, press "Run" / Save.
4. Next, adapt:
- Enter the required number of keys. It is important that the old keys are erased from memory.
- Remove the key from the ignition and insert the next one (switching on the ignition).
- Wait 2-3 seconds until the immobilizer light goes out.
(Do the same with all the keys that are available).
Adapt the key to the CPU block as follows :
1. Choose the Address of block 35 Central locking control module.
2. Select function 10 Adaptations.
3. Select Channel 21 .
4. Specify the memory location where we will prescribe the key (there are 4 of them, see which are available / free in the measurements, in group 021) by number from 1 to 4.
5. Choose the "Test" .
6. Press the " open " or "close" button on the keychain.
7. Save.
Read about Vasya Diagnost's VCDS coding here.
